文献类型：期刊文献

中文题名：含间隙转塔传动系统机电联合仿真研究

英文题名：Study on Electromechanical Joint Simulation of Transmission System with Clearance Turrets

作者：李永聪 袁森 樊战军 陈海虹

第一作者：李永聪

机构：[1]贵州大学机械工程学院,贵州贵阳550025;[2]贵州理工学院机械工程学院,贵州贵阳550003;[3]贵州航天天马机电科技有限公司,贵州遵义563000

第一机构：贵州大学机械工程学院,贵州贵阳550025

年份：2022

期号：4

起止页码：170-173

中文期刊名：机械设计与制造

外文期刊名：Machinery Design & Manufacture

收录：CSTPCD;;北大核心:【北大核心2020】；

基金：XX转塔动力学建模与仿真模拟研究(QC20190037);贵州省重点学科建设计划(黔学位合字ZDXK[2016]22号)。

语种：中文

中文关键词：传动系统;间隙;ADAMS;Matlab;三环控制;PI控制算法

外文关键词：Transmission System;Clearance;ADAMS;Matlab;Three-Loop Control;PI Control Algorithm

摘要：针对发射车转塔控制系统调试周期长的问题,设计了基于ADAMS和MATLAB的机电联合仿真系统。从理论上分析了齿侧间隙和轴承间隙的耦合关系以及对传动系统动力学的影响机理。采用UG建立了含间隙的传动系统三维模型;导入到ADAMS后进行了运动学仿真并验证了可靠性;在MATLAB中搭建了基于PI的三环控制系统,与ADAMS/Control接口模块对接后进行了联合仿真。仿真结果表明,搭建的机电联合仿真系统具有良好的动态响应和轨迹跟踪特性,为实际参数调试提供了一定参考,进一步证明该方法可有效提高调试效率。
In order to solve the problem of long debugging cycle of rotating tower control system of launcher,a electromechanical joint simulation system based on ADAMS and MATLAB is designed.The coupling relationship between tooth side clearance and bearing clearance and the influence mechanism on transmission system dynamics are analyzed theoretically.The three-dimensional model of transmission system with clearance is established by UG,the kinematic simulation and reliability are verifiedafter it is imported into ADAMS,and the three-loop control system based on PI is built in MATLAB,and the joint simulation is carried out after docking with ADAMS/Control interface module.The simulation results show that the electromechanical connection is built.The combined simulation system has good dynamic response and trajectory tracking characteristics,which provides a certain reference for the debugging of practical parameters,and further proves that this method can effectively improve the debugging efficiency.