文献类型：期刊文献

英文题名：Microstructures and mechanical properties of Al-Mg2Si-Si alloys resistance spot welded with Al-Si interlayers

作者：Qin, Qingdong Zhao, Honglong Zhang, Yingzhe Li, Juan Wang, Zhenglong

第一作者：秦庆东

通信作者：Qin, QD[1];Zhao, HL[1]|[14440b8f0a27c8b88f113]秦庆东;

机构：[1]Guizhou Inst Technol, Key Lab Light Met Mat Proc Technol Guizhou Prov, Guiyang 550003, Guizhou, Peoples R China;[2]Guizhou Inst Technol, Dept Mat & Met Engn, Guiyang 550003, Guizhou, Peoples R China;[3]2011 Special Funct Mat Collaborat Innovat Ctr Gui, Guiyang 550003, Guizhou, Peoples R China

第一机构：贵州理工学院

通信机构：corresponding author), Guizhou Inst Technol, Key Lab Light Met Mat Proc Technol Guizhou Prov, Guiyang 550003, Guizhou, Peoples R China.|贵州理工学院;

年份：2019

卷号：8

期号：5

起止页码：4318-4332

外文期刊名：JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T

收录：;WOS:【SCI-EXPANDED(收录号:WOS:000486630400063)】；

基金：This work was supported by the Program for the Distinguished Young Scientific Talents of Guizhou, China [Qian Ke He Platform and talent (2016) 5633], the National Natural Science Foundation of China [51564005], and the Guizhou Provincial Higher Education Engineering Research Center, China [Qian Jiao He KY (2017) 021]], and the Technological Innovation Talent Team of Guizhou Province, China [Qian Ke He Talent Team (2015) 4008].

语种：英文

外文关键词：Al-Mg2Si-Si alloy; Resistance spot welding; Interlayer; Microstructure; Mechanical properties

摘要：This study investigates Al-Mg2Si-Si alloy joints produced via resistance spot welding (RSW) with and without the use of Al-Si interlayers. The joint microstructures produced both with and without Al-Si interlayers consist of three zones: the base material (BM), the heat affected zone (HAZ) and the weld nugget (WN). The WN is oval, and increases in the welding current increase the WN size in both welding methods. The joints produced via RSW with an Al-Si interlayer have larger WNs than those produced without an interlayer under the same welding current conditions. Relationships between the welding current and the WN size are established by Gaussian fitting and Lorentz fitting. A comparison of the two welding approaches shows that a successful weld can be obtained at a low welding current when an Al-Si interlayer is used, whereas a larger welding current is required to obtain the same result without the use of an Al-Si interlayer. The transition layer (interface between the HAZ and the WN) in the joints welded without an interlayer is a single eutectic phase structure; however, in the joints welded with an interlayer, the transition layer generates an equiaxed-columnar crystal zone. The formation of the equiaxed-columnar crystal zone and the change in composition of the WN (according to the results of differential scanning calorimetry tests) improve the tensile-shear loads (TSLs). The equations of the peak TSLs as a function of the welding current and WN size are established by Gaussian fitting. (C) 2019 The Authors. Published by Elsevier B.V.